Silipell SP2

Silipell SP2 is a water-repellent admixture for concrete, enhanced with silicone nanotechnology. When Silipell SP2 is added to the mix, water permeability and unsightly efflorescence are virtually eliminated, protecting concrete masonry from damage caused by weather-related water uptake.

Silipell SP2 is designed for wet-cast concrete products, including ready-mix concrete, pre-cast concrete, mortar, renders and other cementitious products.

Some of the features of Silipell SP2 include:

  • Reduces water absorption and efflorescence
  • Bonds to the substrate and cannot be washed out
  • Leaves no oily residue on the concrete
  • Easy to use in any existing concrete process
  • The degree of water resistance can be varied by changing the dosage rate
  • Contains no VOC and is non-hazardous

Dosage

Use 0.1 to 1 kg of Silipell SP2 per 1,000 kg of dry concrete mix. A typical rate of 0.5 kg per 1,000 kg gives significant water resistance and efflorescence control. The best rate depends on the mix design and the level of water repellency required, so run a trial first.

Chart: capillary water absorption of a 25 MPa concrete mix falls as the Silipell SP2 dosage rises from 0.25 to 1 kg per tonne, compared with a control mix

Adding to the mix

Stir Silipell SP2 before use and pre-dilute it with about ten times its weight of clean water (for example 0.5 kg in 5 kg of water). Mix the dry ingredients, add about half the gauging water, then disperse the diluted Silipell SP2 into the mix while blending. Blend thoroughly and add more water if needed for the right consistency. Cure the concrete in a proper curing room: no further water should be applied to assist curing.

Available in 20 litre drums.

Buy online:

Silipell SP2 20 Litre

Silipell SP2 20 Litre